Introduction
Easily replace your UPS battery after finding the needed new battery by model number.
-
-
Turn off and unplug your UPS from wall power, then turn it upside down.
-
Pull the yellow tab loose, to disconnect the battery.
-
-
-
Use a long number 2 phillips screwdriver to remove 4 screws so you can open the case.
-
This may be difficult to find an appropriate screwdriver. You will also possibly need to gently pry between the two pieces of the case with a small flathead screwdriver to separate the two pieces of the case.
-
-
-
Disconnect and remove the battery from the case.
-
Install the new battery and connect it, noting the red and black color coating.
-
To reassemble your device, follow these instructions in reverse order.
One comment
Use a #1;phillips head screwdriver.
I own an APC RN450M. A #2:phillips head screwdriver doesn't work with that 450 VA model. In fact it doesn't even fit in the screw holes.
But a #1;phliips head screwdriver with at least an 8 inch shaft woks fine.