AcuRite 02032 Base Replacement

Written By: Ben Kegel

Comments: 0

Difficulty

Easy

Steps

Time Required

5 minutes

Introduction

This guide will instruct how to open up the casing of the Acurite 02032 weather center. This guide is very simple to follow and only requires a screwdriver. A screwdriver with a longer extension is recommended to reach deep screws.

Tools

Phillips #1 Screwdriver

Step 1

Remove the battery compartment lid by lifting upward.

Step 2

Pull the ribbon to eject the 2 X AA alkaline batteries.

Step 3

Once the batteries are removed, it is safe to proceed.

Step 4

Remove the four 0.8cm screws that attach the bottom panel to the device
An extended driver is needed to reach 3 of these screws. If you are using the 64 - bit driver kit you can extend the driver by inserting the driver PH1, (Phillips size 1) into the size 4 hexagonal adapter.