Basis B1 Band LED Screen Replacement

Written By: Kaitlyn Lee
  • Comments: 0
Basis B1 Band LED Screen Replacement

Difficulty

Difficult

Steps

11

Time Required

20 - 30 minutes

Introduction

This guide shows how to replace the LED screen. This is a more complicated guide because it involves removing the back plate of the watch along with the battery.

  1. PaYMYrncXTwxbFe2

    • Wedge a plastic opening tool between band contacts.

  2. DQLAL1Q6aATreEEU

    • Push in plastic opening tool until the components click and pop out of the holder.

    • Repeat steps for other band.

  3. FLC4qkshsf3AILmR

    • Remove four 4mm screws using a PH000 screwdriver.

    • Remove back plate.

  4. YMQvugUmRlbPoEe6

    • Use tweezers to remove elastomeric, or zebra, connector.

  5. fDxKd2FpGNrpqsJG
    fDxKd2FpGNrpqsJG
    6YJDCdnko3Vs2WtE

    • Use the flat end of the spudger to carefully lift the battery until adhesive seal is broken.

  6. ZC5LxmHuGpvekEfE

    • Use the pointy edge of the spudger tool to detach battery leads from the circuit board.

  7. ZFExwSY2nAXSCAqb
    ZFExwSY2nAXSCAqb
    1RXEswR1bDvZS2ma

    • Use PH000 screw driver to remove two 6mm bracketed screws.

    • Remove bracket.

  8. fw1aTn2OI5vymPEy

    • Use PH000 tool to remove two 4mm screws.

  9. UPLYRdYrJNSDUZNZ

  10. lRGwsFv3NN2Hjx5w

    • Use spudger tool to lift the clasp of LED connector strip and remove from watch case.

  11. gYFAPCLuU3IqXWlX

    • Use spudger tool to remove the LED screen from the watch case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Kaitlyn Lee

Member since: 06/11/17

518 Reputation

0 comments