Beats Studio 2 Wireless Battery Replacement

Written By: Jack Wilson
  • Comments: 0
Beats Studio 2 Wireless Battery Replacement

Difficulty

Moderate

Steps

5

Time Required

25 - 40 minutes

Introduction

If your Beats Studio 2 Wireless headphones will not turn on or charge, it's possible the battery needs to be replaced. Use this guide to remove and replace the battery of your headphones.

For additional information on troubleshooting this issue, refer to the Beats Studio 2 Wireless troubleshooting page.

  1. eTaBuYfLjPfjupAu
    eTaBuYfLjPfjupAu
    H5kWWPPSI3Ymi6uu

    • Using a spudger, remove the panel circling the ‘b’ Beats logo on the right earphone by applying pressure upwards under the panel until it is removed.

  2. 1yAARcryQ6nYKOXh
    1yAARcryQ6nYKOXh
    DUrRhi2betxDmoec

    • Remove the four screws securing the housing with a Phillips #00 screwdriver.

  3. aCLSjfYlyHZLmxvJ

    • Use a spudger to release the clip in the seam under the silver “studio” label.

    • Remove the right side of the headband.

  4. XGlJBRbCwQ6BCHwn

    • Gently remove the right earphone speaker from the headband by sliding the speaker downwards.

  5. 23qE2sBWiiNlwm3N
    23qE2sBWiiNlwm3N
    xN3OJ1hRwDy4pNSH
    tE6QYepUFO6ERSsI

    • Use the pointed tip of a spudger to carefully push on each side of the connector to release it from the socket on the motherboard.

    • Be gentle with the connectors as they can break easily.

    • Don't use a metal spudger to remove a battery or any internal component. This is potentially dangerous as it could puncture the battery and cause a fire or worse.

    • Use a nylon spudger to remove the battery from the headphones.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jack Wilson

Member since: 20/03/23

485 Reputation

0 comments