Brewologist Turbo Milk Frother Connector Between Electric Motor and Wisk Replacement

Written By: Eric Molina
  • Comments: 0
Brewologist Turbo Milk Frother Connector Between Electric Motor and Wisk Replacement

Difficulty

Moderate

Steps

5

Time Required

No estimate

Introduction

  1. TDL2aQSGj3qBj42c

    • AliExpress is a good source if you don't mind the long shipping time.

  2. v1Q1SwZOjMhA3MEp

    • Amazon was a good source.

  3. kiGGISvSMyZW6Jbr

    • Tighten the hex head screws evenly on both sides.

  4. u2xkKGXTTbSgGImB

    • With the hex head screws removed, hold the coupler with pliers when drilling. Drill the 3mm coupler end with a 3.1mm drill bit past the hex screw holes. Attach the wisk and tighten the hex head screws evenly on both sides.

  5. nHt2XvcAUQfVTCTs

    • All done.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Eric Molina

Member since: 26/06/18

168 Reputation

0 comments