DeWalt DC970 Clutch Replacement

Written By: Jonathan Hamel
  • Comments: 1
DeWalt DC970 Clutch Replacement

Difficulty

Moderate

Steps

6

Time Required

10 minutes

Introduction

If you are having trouble controlling the speed of the drill there may be a problem with your clutch. By following this guide you will learn how to replace it.

  1. iFAWbJDnhLhVdAlL

    • Compress the buttons on either side of the battery and lift the drill away from battery.

  2. rtlRZBdsGVSNifqH

    • Remove battery from drill.

  3. FshZipNC1Ae5umqy
    FshZipNC1Ae5umqy
    YYjY4mpiI4TYpser

    • Remove the eight 16 mm, Torx Security #15 screws.

  4. RGX65BULtpBxULxV

    • Lay the drill on its side and gently lift the top half off it.

  5. JQxpFG1yicoe5sgG

    • Lift drill mechanism from the drill assembly.

  6. ZVbcRTThcLmIGhbV
    ZVbcRTThcLmIGhbV
    lVXG1iwCx1bb5WQR

    • Twist slightly and pull clutch away from motor.

    • Remove clutch.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jonathan Hamel

Member since: 10/03/16

591 Reputation

One comment

worthless no info about clutch

bowlweevil -