DeWalt DC970 Forward/Reverse switch Replacement

Written By: jake
  • Comments: 0
DeWalt DC970 Forward/Reverse switch Replacement

Difficulty

Moderate

Steps

6

Time Required

15 minutes

Introduction

This guide will teach you how to properly replace your forward/reverse switch for this device.

  1. iFAWbJDnhLhVdAlL

    • Compress the buttons on either side of the battery and lift the drill away from battery.

  2. rtlRZBdsGVSNifqH

    • Remove battery from drill.

  3. FshZipNC1Ae5umqy
    FshZipNC1Ae5umqy
    YYjY4mpiI4TYpser

    • Remove the eight 16 mm, Torx Security #15 screws.

  4. RGX65BULtpBxULxV

    • Lay the drill on its side and gently lift the top half off it.

  5. MgKXuvBGxUixTR4k

    • Remove the drill mechanism from the shell.

  6. x5FIGrcPwOVBCuIy
    x5FIGrcPwOVBCuIy
    gTmGpZVNpcKnuj54

    • Disconnect the forward/reverse switch from the trigger by pulling the mechanism out and leaving the switch in the frame.

    • To replace just pull the switch out and put the new one in the opening.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

jake

Member since: 10/03/16

303 Reputation

0 comments