Dell Latitude 9410 2-in-1 SSD Replacement

Written By: Jessica Stephens
  • Comments: 0
Dell Latitude 9410 2-in-1 SSD Replacement

Difficulty

Moderate

Steps

6

Time Required

10 - 20 minutes

Introduction

Use this guide to replace the solid state drive (SSD) of the Dell Latitude 9410 2-in-1.

If you're finding many corrupted files or data, software incompatibility, hard drive errors, or an overall faulty SSD, the SSD may need to be replaced entirely. Be sure to check the troubleshooting page before moving forward with replacement.

  1. AYC1YKfmwof4Jwty

    • Ensure that the laptop is unplugged and powered off before beginning.

    • Place the laptop upside down on a flat surface.

  2. ynIr1NqMFFiOjWND
    ynIr1NqMFFiOjWND
    rhBiBAx1FTwh5ODf

    • Use a Phillips #00 screwdriver to loosen the ten captive screws.

    • The screws are permanently fastened to the base panel; do not attempt to remove them.

  3. GuHQBTHYlavdulJP
    GuHQBTHYlavdulJP
    asAXStlTtcyfvROb
    Z1xLSZYcQe3KdRaA

    • Carefully lift off the back panel.

  4. JMWbJUGFtYxPYvSh
    JMWbJUGFtYxPYvSh
    1Im2TDUasHSiUdAG
    3tA51t2eaJmm2oSy

    • Carefully peel back and remove the black tape around the top left corner of the motherboard.

  5. tuhCWXH3luSvvuXp
    tuhCWXH3luSvvuXp
    NTBnGCmqicFhoOoG
    iV5rAqfRvNQf5SZ6

    • Use a Phillips #00 screwdriver to remove the 2 mm screw, loosening the bracket that covers the SSD.

    • Carefully lift the off the bracket.

    • The bracket is attached to the laptop and cannot be removed completely.

  6. PUwgoZJAoZsr1lDW
    PUwgoZJAoZsr1lDW
    scI2fLdjWNdLeLnD
    EBjUoiCiqhopOswX

    • Grip the SSD and pull directly backward until the SSD releases from its port.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jessica Stephens

Member since: 08/02/22

558 Reputation

0 comments