Dreamer Autoshade Motor Set Screw Adjustment

Written By: David
  • Comments: 0
Dreamer Autoshade Motor Set Screw Adjustment

Difficulty

Easy

Steps

3

Time Required

2 minutes

Introduction

  1. FMA1QcyIpmIRviVB
    FMA1QcyIpmIRviVB
    f1I1lXDq2VP2KYkf

    • Remove the four Phillips head screws that fasten the motor hub to the tube adapter.

  2. gtm4EbuamRrgkuRW
    gtm4EbuamRrgkuRW
    F3rhfu43wNOqIDgq

    • Using a flathead screwdriver, pry the bearing cap from the tube.

  3. XbnOeUpVfbpYqCfg

    • Move the hub to the edge of the shaft so it is flush, and tighten the set screw using a T5 screwdriver bit.

    • The hub should fit snugly on the shaft, unable to rotate freely.

    • Optional- Add a drop of thread locking liquid to permanently hold the set screw in place after tightening.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

David

Member since: 11/11/20

734 Reputation

0 comments