Introduction
Tools
-
-
Remove the 3 screws using a Phillips #1 Screwdriver (Red)
-
Remove the 2 Standoffs using a 5mm socket
-
-
-
Remove top screw using a Phillips #0 screwdriver (Blue)
-
Remove the bottom screw and nut using a Phillips #0 screwdriver. Will want to use a finger to hold the nut from spinning while releasing the screw.
-
-
-
Gently slide the plate out from between the back cover and the circuit board. It should come out without much force.
-
If it doesn't want to budge, check that the right screw was removed from the top of the video card.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.