Electric Bike Throttle Replacement

Written By: Ali Al-hamadani
  • Comments: 0
Electric Bike Throttle Replacement

Difficulty

Easy

Steps

7

Time Required

20 minutes

Introduction

Use this guide to replace your Electric Bike Throttle.

  1. gIvFXpjBRLCx3LIT

    • Before starting to disassemble your electric bike, turn the power off.

    • Remove the 3/32 inch Allen screw.

    • When removing Allen screw, make sure the driver is well seated because they are simple to strip.

  2. oTPnCgVdIPheSyIU

    • Locate the throttle Allen screw.

    • Remove the 5/64 inch Allen screw.

  3. gMqCjMWIlaAIjs6x

    • Slide the Throttle off.

    • When removing the throttle, be careful. Remove it slowly to avoid damaging the wire.

  4. UiyDH15CBQDcSxrk

    • Remove the following screws.

    • 2 mm Philips screws.

  5. j3XjlEIS2cg4bdll

    • Open up the control box.

  6. QipwBQWRWOBcOIMa

    • Track the throttle wire.

    • To ensure you don't lose it, you should mark it.

  7. dClwQ1wWGlAfp6JP

    • Locate the throttle wire.

    • Disconnect the throttle wire plug from the controller wire plug.

    • Take caution while handling these wires. You can easily damage them.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Ali Al-hamadani

Member since: 06/10/22

145 Reputation

0 comments