Flip Video Ultra Power button Replacement

Written By: Nathaniel Ruf

Comments: 0

Flip Video Ultra Power button Replacement

Difficulty

Moderate

Steps

Time Required

15 minutes

Introduction

This guide will walk you through on how to remove the power button and replace it. You will need the iFixit Opening Tool and the Phillips #1 Screwdriver. It should take no more than 15 minutes, if it takes more than that then you may have done something wrong.

Tools

Step 1

Unlock the battery cover by sliding the switch to the unlock position.

Step 2

Remove the battery cover by sliding it down the camera.

Step 3

Remove the batteries

Step 4

Slide the black upper casing off from the device.

Step 5

Remove the six 1mm screws from the back and upper casing with the Phillips Head screwdriver.

Step 6

Remove the top casing from the bottom to reveal the inner circuit board.

Step 7

When removing the back panel, the rubber buttons will become loose and likely fall off the board. This is normal and can easily placed back on the board once finished.
Remove the six 1mm screws with the 1 Phillips head screwdriver.