HP iPAQ h4155 Back Case Replacement

Written By: John Pagliero
  • Comments: 0
HP iPAQ h4155 Back Case Replacement

Difficulty

Easy

Steps

7

Time Required

5 minutes

Introduction

This step-by-step guide illustrates how to remove and replace the back case of a Pocket PC.

  1. Upv2uOgRofWIZLid

    • While sliding the silver release tab up, simultaneously lift the cover up from the left side.

  2. HDprHUJ2VGQyPJNX

    • Push the tab left to right to remove the cover.

  3. WRiwBpkNWER5SSxE

    • Now, lift the battery up and away from the device to remove it.

  4. vfkeXmnIYFE3ivBe

    • Remove the four silver screws using the T5 Torx Screwdriver (T5 x .25 in).

  5. rOVcOI11Dy2TFvJq

    • Remove the single black screw that is located beneath the HP sticker with the T5 Torx Screwdriver.

  6. Z3IBC3XV6tH2D4kU
    Z3IBC3XV6tH2D4kU
    kTr6qgV1mAPQXEwD

    • Next, use your plastic removal tool to separate the gray back from the black center piece.

    • For better results, start the separation at the corner piece.

  7. FGQhLS6W4WegB1aP

    • Remove the back case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

John Pagliero

Member since: 27/01/11

942 Reputation

0 comments