Handspring Visor Edge Back Panel Replacement

Written By: Nick Lazarakis
  • Comments: 0
Handspring Visor Edge Back Panel Replacement

Difficulty

Moderate

Steps

5

Time Required

5 minutes

Introduction

The only tool needed is a #00 Phillips Screw driver.

  1. tEKoGQZsFrcuCTwE

    • Remove the six 4.1 mm Phillips screws from the back plate using the #00 Phillips Scewdriver.

  2. nyfOtUGYbEddVfjC

    • Remove the gray back plate from the PDA.

  3. tKD1NBSQmbcEgDmO
    tKD1NBSQmbcEgDmO
    bQkWKp1RSmP2cVkK

    • Remove the four 2.6 mm Philips screws that are on the sides of the frame.

    • Remove the 3.9 mm Philips screw holding the stylus holster to the frame.

  4. eVBHWGZ1GcntvSyw
    eVBHWGZ1GcntvSyw
    aElQdqUNMHMa2VVe

    • Remove the four 2.6 mm Philips screws on the top and bottom of the frame.

  5. BjNOalaltV2Ra1fy

    • Remove the white frame from the back of the PDA.

    • The frame may get stuck on the corners so be very gentle when working the corners off.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Nick Lazarakis

Member since: 24/01/11

331 Reputation

0 comments