Hasbro Iron Man Infinity Nano Gauntlet LED Lights Guide Replacement

Written By: Jessica
  • Comments: 0
Hasbro Iron Man Infinity Nano Gauntlet LED Lights Guide Replacement

Difficulty

Moderate

Steps

6

Time Required

No estimate

Introduction

The Hasbro Iron Man Infinity Nano Gauntlet is not much without its radiant gems. If the LED lights within your gauntlet are faulty, here is an effective way to fix them.

  1. k2JEDQnC6OvlK6SE
    k2JEDQnC6OvlK6SE
    kIOBZ4N3isQWFuBL
    hDfGthEwLKZ2YH4B

    • Find the removable panel at the bottom of the hand.

    • Use your finger to push upwards and open the panel.

    • Slide the panel off and separate it from the hand.

  2. YB6HxqUMKcQ3Aq3f
    YB6HxqUMKcQ3Aq3f
    Ox1kecthg3AJfpib

    • Remove the left-most battery by pushing down on the positive end and pulling it out.

    • Repeat this for the next two batteries.

  3. Djhhf3jIhMhYRBQG

    • Remove the screws within the gauntlet and surrounding the palm.

  4. QJtbIuVkyBQIUeaH

    • Open the gauntlet carefully, as there are wires connecting both sides.

    • Address which LED is faulty. Check if the wires connecting to it are all intact; If there is a detachment within the circuits, reconnect it to its location. The LED should operate in that instance.

  5. EYOdN2E2SwUABIvs

    • To replace the LED chip, remove the screw holding the chip in place.

  6. Ip6QTYKtOAXrgD1q

    • Ensure that the LED chip is in the correct area with the correct polarity.

    • Reconnect it to its respective surface and check if it fits with in the magnetic gem. If not, consider another replacement.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jessica

Member since: 24/02/23

109 Reputation

0 comments