Introduction

Did your expensive hockey gloves rip while playing with them, putting a hole in your palm and an even bigger hole in your wallet? Well, do not fret, as this guide to repairing a hole in your hockey glove works for all shapes, sizes, and most importantly, sticks within your budget.

Wear and tear is a natural thing that occurs on hockey gloves as they are used over time. Often, it is possible to repair holes on the palm to avoid having to pay for replacements.

Make sure to inspect the glove before following through with the following steps. It is important to keep in mind that some holes are too large to fix. If the wear covers more than unworn portion of the glove, it may be time to replace the whole palm.

  1. 5XgEY1KWhKAF5jbO
    • Using measuring tape, measure the dimensions of the hole to approximate how much material is needed.

  2. D5WSU4PC6ceKwFBc
    D5WSU4PC6ceKwFBc
    DtUXcMf3oYRiIxlH
    • Using the dimensions gathered from the previous step, cut the fabric to size leaving some excess material.

    • You can use fabric from other gloves that are still intact to repair the glove in need.

  3. 2shVNilTENMgeuJW
    • Draw an approximate shape of the hole on the fabric as a guide for stitching using a marking tool that will show up on fabric.

  4. MsfCrLikgOQrCjGW
    MsfCrLikgOQrCjGW
    eEViNUpFf21uTSfN
    • Thread a needle with enough thread for the size of the hole you are repairing.

    • A sewing machine can be used instead of hand sewing if you would prefer.

  5. kDBywVmwBclI6guP
    kDBywVmwBclI6guP
    TvJFDSBGTMWmFDEA
    • Apply the adhesive to the perimeter of the hole.

  6. 6OLJwLfJsDZbBsxM
    • Position the material on the glove to completely cover the hole leaving a bit of overlap.

    • Allow the adhesive time to dry so that the material is firmly stuck to the glove.

  7. r4UuhuRmFaaDpm3t
    r4UuhuRmFaaDpm3t
    QkAfhxbwBAl121JX
    • Reinforce replacement material to the palm through hand stitching.

    • To hand stitch, push the needle through the front of the fabric and pull the thread through. Do the same from the inside of the glove. Continue to weave in and out creating stitches that are as close together as possible.

  8. adjNAtjfGh2kXl2I
    • Trim excess the material from around the area of replacement

Conclusion

To reassemble your device, follow these instructions in reverse order.

Dora D'Accardo

Member since: 19/04/23

157 Reputation

0 comments