Introduction

This guide will show you how to fill gaps and replace the latex caulk between a wall and a sink (or anywhere in your home that may need recaulking). The new latex caulk material will be added to the gaps using a latex caulk gun.

  1. KCe2TAqAlf3e2U2V
    KCe2TAqAlf3e2U2V
    seTGDOHPJUEMYHlW
    PAKyRaAACZm1H2JZ
    • Clean all surfaces and remove any clutter.

  2. 3x3CBMkHpPdWlHyQ
    3x3CBMkHpPdWlHyQ
    KVAEl2XBwvPHvwBB
    qJSU4uVReMRm3KUU
    • Use the latex paint remover spray for the areas that have remaining material along with the gaps. These areas also need to be replaced with new material.

  3. WC1HjRKBcbnSOyMj
    WC1HjRKBcbnSOyMj
    WccARur1RjRMvmoS
    k3LktbRhccXvORfj
    • Use scissors to cut the head of the caulk tube at a 45 degree angle.

    • This will help to better fill the gaps.

  4. l1sptQKJqDLPFPZh
    l1sptQKJqDLPFPZh
    yljKXajHFRBYBUvF
    wwBdypfKKixFfekL
    • Insert the seal punch into the tip of the latex tube to pierce a hole.

  5. efahdon1GJ5ZYIin
    efahdon1GJ5ZYIin
    XRnpJFQAFhSkc1rJ
    6YgEVuIGsEAAYWRy
    • Pull back the handle of the caulk gun.

    • Place the caulk tube inside it.

    • Twist the metal bar until it is completely inside the caulk tube and the curved handle is on top.

  6. c2QnBEZ3rEbBWN51
    c2QnBEZ3rEbBWN51
    cujoDYSRrDHqtO4x
    lSsRVyqTcGCTpYIS
    • Add the latex to the areas you see gaps.

    • After finishing each side, slide your finger along the caulk to push the material inside the gaps.

    • Use a wipe to immediately clean the excess from the filled areas.

  7. P4m3F2dWvurWOySL
    • Use latex remover spray to remove any material stuck to your hand.

Ehsan Alagheband

Member since: 16/09/21

153 Reputation

0 comments