Jabra Elite 85h Speaker Replacement

Written By: Matt Gardiner
  • Comments: 1
Jabra Elite 85h Speaker Replacement

Difficulty

Easy

Steps

6

Time Required

15 - 20 minutes

Introduction

If you are having problems with the audio output from one or both speakers on this headset, you may need to replace the speakers. Follow this guide to correctly disassemble the headset and replace the speakers. This guide shows the steps for only one side, but the process is identical for both speakers.

  1. QVOnAI6Th1tUpOWC
    QVOnAI6Th1tUpOWC
    S5T3TTIaLsOa3hTv
    LeDtQRnBKONgQGHB

    • Remove each ear cushion by hooking your fingers along the inside of the ear cushion and pulling up and away from the ear cup.

    • If the cushion does not fully release, move your hand to the opposite side and pull up inn the same manner.

    Hi sir, I think your guide is incomplete. Do you have the opportunity to bring a sequel?

    Oğuzhan Sancak -

  2. MOSSox6BGbM5ZQFN
    MOSSox6BGbM5ZQFN
    SLQCZDbxtCPmFtJT
    ZDDeK4deyGILEOFK

    • The foam inserts and backing tape are very delicate. Take your time when removing them, and be careful to not rip or tear the material.

    • Using the small plastic spudger to assist, begin lifting up and removing the foam inserts with attached backing tape.

  3. HV1i5TsUTIQMMeTo
    HV1i5TsUTIQMMeTo
    eIrhHuOApTKbIRvp
    GJ4OH2eyn3xRSoIP

    • Repeat the previous steps for the other side, removing the foam inserts with care.

  4. Olkaoy4RCCYbMcVw

    • Unscrew and remove the four T6 screws holding the speaker in place.

  5. glKFtkWgwLaOTTDH

    • Repeat the previous step for the other side, removing the four T6 screws.

  6. CFmZL4vkObKq1Qm6

    • Tilt the headphones over so that the speaker tilts out of the plastic holder.

    • Repeat for both sides.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Matt Gardiner

Member since: 15/03/23

243 Reputation

0 comments