Lenovo Tab S8 Battery Replacement

Written By: Temi Adegoke

Difficulty

Easy

Steps

Time Required

30 minutes

Introduction

If your battery seems to drain quickly while in standby mode, just follow the simple steps in this guide and you will be back in business in no time!

Make sure the device is powered off.
Gently insert a spudger into one of the bottom corners between the screen and body case.
Slide the spudger along the inside of the crack in order to pry the case open.
Be careful of the small volume and power buttons when prying the case with the spudger. They are connected with small pieces of plastic that break easily.

Bought a battery connector gets hot and doesn't turn on

After removing the cover, remove the M1.6 x 2 mm screw from the battery cable with the JIS J000 screwdriver.
Using screwdriver bits that do not fit in the screw head might strip the screw and render it unusable.
Remove the tape by gently scraping the edges up with the spudger.

Before removing the battery, be sure to disconnect the ribbon cables underneath it. The cables might stick to the battery during removal and cause damage.
Gently lift the flaps on the four ZIF connectors to disconnect the cables.
Use the plastic card to gently pry the battery from the device.
There may be glue holding the battery to the device. Use the spudger to detach any glue while the battery is partially raised by the card.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Member since: 26/08/15

417 Reputation

Where we can buy battery