Lenovo Yoga 920-13IKB Battery Replacement

Written By: Alyssa McCulloch

Comments: 14

Lenovo Yoga 920-13IKB Battery Replacement

Difficulty

Moderate

Steps

Time Required

4 - 5 minutes

Introduction

This guide will show you how to replace the Lenovo Yoga 920-13IKB's battery.

Tools

Parts

Lenovo Yoga 920 Battery

Step 1

Flip the device over to access the screws on the back cover.
Remove the ten 5mm Torx T5 screws on the back cover to loosen the back cover.

Step 2

Slide the iFixit Opening Tool under the back cover to lift it up.
Pull up on the cover with your hand to release the tab holding the center of the cover in place.

Die Mitte der unteren Abdeckung wird von zwei Plastiknoppen am Gerät gehalten. Wenn die Schrauben gelöst sind, mit beiden Händen unter die Abdeckung greifen und nach oben gerade wegziehen.

Captainquark -

Step 3

Remove the four 5mm Phillips #00 screws that hold the battery in place.

Step 4

Grab the grouping of wires with your fingers close to the connector and gently pull to disconnect the battery from the motherboard.
The wire grouping is located underneath the thin flap near the center of the battery.
Do not lift the battery out before disconnection from the motherboard to prevent shortages or damage.

This was the hardest step for me. My comments: The thin flap covering the wires is just a flap of the plastic covering around the battery. The connector fits tightly, needs to be really tugged out. You may need to bend the group of wires to get the new connector to seat in place. There will be a thin edge of the connector still sticking out when you have it seated. I needed to use a very thin bit from the ifixit kit to press the new connector into place. Great guide, worked perfectly!

Spr -

Step 5

Use the iFixit Opening Tool to lift the battery up enough to grab it with your hands.

Step 6

Remove the battery.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Alyssa McCulloch

Member since: 24/01/19

1807 Reputation

12 comments

What is the correct replacement battery for this device?

Stephen Prather - 03/10/19

Nice writeup!

Tim Averett - 01/09/20

Simple, a real simple straight forward process with the right tools of course. Thanks

Daniel Smith - 11/11/20

Thank you, was very easy replace battery using your guide!

Andrejs -

Simple and easy. Great guide to! Thanks so much

Isaac Stahl -

I completed the replacement but when I turn on the computer I have gotten one of two messages: 1) incorrect voltage, 2) no battery detected. Therefore the battery isn’t charging. What should I do?

Richard Ho -

The instructions and photos were spot on. I would suggest adding a optional step of vacuuming or air spraying the interior after battery removal. Maybe adding Loctite to the screw although I don’t think my PC needed more.

98382-6712 98382-6712 - 13/02/22

I would not recommend either using Loctite or vacuuming. Unless you subject your device to ungodly amounts of vibration (which you still shouldn't do) using loctite will do nothing besides make your life harder next time you have to open the case. Vacuuming can spin the fans and cause them to induce a current that can destroy parts of your device.

Robb -

Les réparations impensables chez le marchand sont devenues très faciles

Pierre-Alain Ramoni - 24/09/22

Exactly what I needed, worked great, thank you!

Spr -

After battery replacement what happens with BIOS? It does not appear that there is a CMOS battery. Just want to ensure after install what to do if BIOS resets?

Tushar Padhiar -

Good morning

I have problem to turn on my laptop after battery replacement.my power botton dont work ,i have to plug in laptop so he turn on automaticly,the new batter is fine,so after that i can use the power botton to turn on off the laptop.but after shuting down laptop for few minutes,the power botton dont work again,and i have to plug it on to run it.when i put on the old battery no problem.can u help resolving this trouble.

Madani Mokrane -