Makita Jack Hammer HM1203C 2010 Motor Cover Replacement

Written By: Adam O'Camb
  • Comments: 0
Makita Jack Hammer HM1203C 2010 Motor Cover Replacement

Difficulty

Moderate

Steps

2

Time Required

1 - 3 minutes

Introduction

Use this guide to remove or replace the motor cover on a Makita Jack Hammer HM1203C 2010.

  1. 1tQ4rEpfJXZA1NYl

    • Make sure the hammer is disconnected from power before beginning any repair.

    • Use a Phillips #2 screwdriver to remove the three screws securing the motor cover.

  2. U2L2NPNyCs62USnK
    U2L2NPNyCs62USnK
    YgbRnmBUVWvwict1

    • Remove the motor cover.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Adam O'Camb

Member since: 11/04/15

183214 Reputation

0 comments