Microsoft Surface Pro 4 Antenna Support Replacement

Written By: Sam Omiotek
  • Comments: 3
Microsoft Surface Pro 4 Antenna Support Replacement

Difficulty

Difficult

Steps

2

Time Required

No estimate

Introduction

This is a prerequisite-only guide! This guide is part of another procedure and is not meant to be used alone.

Follow this guide to remove or replace the antenna support bracket on a Microsoft Surface Pro 4.

  1. 54uLjQBUqFZc1EFA

    • Use a T5 Torx screwdriver to remove the four 4.5 mm screws securing the antenna support bracket.

    This screw bit was not included in the battery replacement kit. Only Philips and Flathead were included.

    ComputerRepairAcct -

    This Torx bit was not included in the battery replacement kit. Only a Philips and Flathead bit

    ComputerRepairAcct -

  2. QCwNOfsMSfRRyodx
    QCwNOfsMSfRRyodx
    uJnAjGV22JRVxFDT
    d6qTZaQ52TbuaKpk

    • Carefully remove the antenna support bracket.

    • Be careful not to snag any cables. Do not force the bracket out if it is stuck.

    I had ripped through 2 of the 3 antennas when cutting through the top adhesive. Not sure how anyone removes this display without ruining at least one of them.

    I saw on Reddit this post: https://www.reddit.com/r/techsupportmacg...

    It works perfectly! My wifi was one that was cut. It’s now made of aluminum foil and is pulling down 147Mbps and pushing 80.88Mbps up.

    Joshua Snavely -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sam Omiotek

Member since: 25/02/19

62518 Reputation

0 comments