Microsoft Surface Pro Speaker Replacement

Written By: Jonathan Choi

Comments: 3

Microsoft Surface Pro Speaker Replacement

Difficulty

Difficult

Steps

Time Required

45 minutes - 1 hour

Introduction

Use this guide to replace the left and right speakers in the Microsoft Surface Pro.

Tools

Step 1

Use a heated iOpener or a heat gun to heat the edges of the display and soften its adhesive.
If you're using an iOpener it may take several cycles of reheating and applying it to soften the adhesive enough. Every time, let the iOpener sit on the display for at least a minute before reheating to allow the adhesive to soften.

Be patient. I spent at least 10 to 15 minutes warming and trying to pry up the screen with my spudgers and such. It got so hot I would use one spudger to hold the Surface from the opposite side while pried with the other spudger from the other side. I would get a little lip up and slide and when I felt resistance then I would heat more and make my way around the screen. I continued that many times until I was able to use the suction cup to pull it up.

Dan - 02/12/22

Step 2

Apply a suction cup as close as possible to the edge of the display.
Use the suction cup to lift the edge of the display enough to insert an opening pick under the edge.
Slide the opening pick all the way around the edges of the display to cut through the adhesive on the bezel.
Do not insert the opening pick past the bezel of the display—you may permanently damage the display.
Be very careful and move slowly during this step. The display is fragile and will crack if too much force is applied against it. If your tools seem stuck, apply more heat to further soften the adhesive.

Step 3

Starting from the top edge, lift the display slightly. If you feel any resistance, use heat and an opening pick to slice through any remaining adhesive.
Before completely removing the display, disconnect the three display cables.

【注意!!】画面ガラスの下部の接着がデジタイザーのフレキケーブルとも接着されています。

両面接着剤の温めが甘かったり、無理に剥がそうとするとデジタイザーのフレキケーブルが切れますので丁寧に作業を行って下さい。

Tacky Sato - 07/08/20

my surface pro 1 has 4 flat flexi-cables connected.

I don’t know how to put back the narrow flexi cable. It is too thin and without a pulling tape?

Kenneth Siu - 02/05/21

Step 4

Remove the display.

Step 5

Unscrew all the 23 screws located on the outside panel with the T5 torx screw driver

Step 6

Use the plastic opening tool to pry out the cameras

Step 7

Pull the outside panel with your hands from the Surface Pro

Step 8

Use the T5 torx screw driver to unscrew the 6 T5 screws located on the left and right metal panels
Use the T2 torx screw driver to unscrew the 23 T2 screws located on the left and right metal panels