Milwaukee 2704-20 Control Switch Replacement

Written By: Unique Linnell

Comments: 0

Milwaukee 2704-20 Control Switch Replacement

Difficulty

Easy

Steps

Time Required

5 minutes

Introduction

This guide is about how to replace a Control Switch for Milwaukee 2704-20 Drill. You will need to use the Milwaukee 2704-20 Disassembly Guide first in order to replace the control switch.

Tools

Step 1

Remove the battery from the drill.

Step 2

Remove the indicated screws (M3 x 16mm Pan Hd. ST T-10 Screws) with screwdriver.

Step 3

Gently lift the cover off the drill. Be careful not to force it or damage any of the internal components.
If the cover doesn't come off easily, check for any clips or latches that may be holding it in place. These can usually be released by pressing them with a small flathead screwdriver.

Step 4

Remove the control switch.
It is not attached to anything and should slide out easily. Take note of orientation and be sure to replace it in the same position.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Unique Linnell

Member since: 13/03/23

409 Reputation