Nikon Coolpix L810 Flash Replacement

Written By: Emilio Mena
  • Comments: 4
Nikon Coolpix L810 Flash Replacement

Difficulty

Moderate

Steps

5

Time Required

10 minutes

Introduction

Is your flash not lighting up? This guide will show you how to replace the flash from your camera.

  1. 1YaTxSLe4ZvjlILF

    • Remove two 5 mm Phillips #000 screws below the flash component.

    • In order to complete this step the flash must be open. To open the flash press the button located above the lens on the leftward side of the camera.

  2. AMHXneNe3vxaUBTa

    • Use blue plastic opening tool to pry open the casing for the flash.

  3. hARwiDiP4CrXBjLs

    • Remove the plastic casing surrounding the flash.

  4. JYQKcDNHoicMJHHe
    JYQKcDNHoicMJHHe
    5LNEdxvEDLHfRNWq

    • Pull the wires connecting the flash out of the camera.

  5. w544UBBucUKVxcKT
    w544UBBucUKVxcKT
    LdP3hrJCjfpgwNvJ
    r2mtx6BcH5fGL1Vy

    • Unsolder the wires that connect the flash component.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Emilio Mena

Member since: 15/01/15

725 Reputation

4 comments

It's not a comment, but where did you obtain the replacement flashbulb?

hgdddee -

the heading says no parts required. but I think i need a new flashbulb? any idea what the type is or where to buy it ?

wildstreaksavannahs -

I can't get into bulb

Szabolcs Demeter -

<a href="https://www.w3schools.com/">Visit W3Schools.com!</a> n advmd vdsm vs ds m

nirik -