Sega Genesis Flashback Controller Batteries Replacement

Written By: Omar Shorab
  • Comments: 1
Sega Genesis Flashback Controller Batteries Replacement

Difficulty

Moderate

Steps

2

Time Required

1 - 2 minutes

Introduction

This guide will help you remove the batteries from your Sega Genesis Flashback controller.

  1. dFlnxZpVJdmije1K
    dFlnxZpVJdmije1K
    g1CiVemCBtbQEldL

    • Using a Phillips #000 screwdriver, unscrew the single screw located on the battery cover. Remove the battery cover and set it aside.

    • The screw does not detach from the battery cover, so do not attempt to separate them.

  2. VxAnZqX3V4RdIQGN
    VxAnZqX3V4RdIQGN
    gmq4IAfUuXiCZPiD

    • If batteries are in the battery slots and need to be replaced, then remove the old batteries by pressing them in and compressing the spring until there is enough space to take them out.

    • Insert two fresh batteries into each one of the slots by pushing the indicated negative end of the battery against the spring.

    • All AAA batteries have “+” and “-” symbols on each end of the batteries to denote the positive and negative ends.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Omar Shorab

Member since: 23/04/18

261 Reputation

One comment

any idea where i can find a schematic for the contoller board. I just bought one of these second hand and the wireless controller won’t connect to the system. I took it apart and it’s missing a small resistor.

Scott Phaneuf -