Introduction

If your battery does not hold charge, we will show you how to open the phone and replace the old battery.


Please SUBSCRIBE to my channel ツ

  1. Qdpf1YwNnMf5SuSL
    Qdpf1YwNnMf5SuSL
    OrnWMLZSciKaBLEn
    WXyx5lgGvkHPysnc
    • Warm the Back Cover. You can use a hairdryer.

    • Be careful, the Cover is plastic.

    • Use a small suction cup and plastic tools for separating the Rear panel.

    • Before installing the new cover, you must clean the phone from the old adhesive tape and install a new one if your spare part has come without double sided adhesive tape.

    One battery

    One camra lance back

    Prince Kushwah -

  2. QMRHwJlAJOtPuGSC
    QMRHwJlAJOtPuGSC
    eREb4pTdVOqxFfeV
    xyoALSuMNjCmliOB
    • Disconnect the Battery Cable.

    • The battery is stuck to the phone fame. Use the white tape to remove it.

    • Li-Polymer Battery, 2230 mAh

    • Part number: LIS1551ERPC

    • Please SUBSCRIBE to my channel ツ

    если первая разборка, отклеивается очень сложно и я бы советовал нагреть модуль до 70-76, на сепараторе. тогда аккумулятор отклеится легче. =)

    Владимир Гусев -

    I see the regular M2 has a large identification sticker. On the M2 Aqua (or at least the one I have) the sticker is shorter, so it’s pretty easy to short out the battery flex contacts against the metal shield located just above the battery connector on the motherboard. Once shorted, the battery seems to go into some sort of “protection mode” and the phone wont boot unless you plug it into a charger first.

    Luis Alejandro Araúz -

Conclusion

To reassemble your device, follow these instructions in reverse order.

ZFix

Member since: 09/12/13

189024 Reputation

0 comments