Introduction

Use this guide to refill and empty stapler, so you can get back to those TPS reports.

  1. WekcYRZT2XjHSc3O
    WekcYRZT2XjHSc3O
    IU1j6N1DpUIBCjYg
    • Be careful while handling staples or any sharp object in general.

    • Grab the base of the stabler, and pull the hammer until the stapler opens, revealing the carrier, pusher, and spring.

    • Identify the staple type by looking on the bottom of the carrier. If the staple type is not on the carrier, look under the base.

  2. oTRlONNPVWTWBvKQ
    oTRlONNPVWTWBvKQ
    WQavLj4DV5RpxQGC
    • Get a cluster of staples and carefully place it in the carrier.

    • Make sure there is enough room for the pusher to contact the staples.

    • Close the stapler by clearing your hand from under the crimp area and pushing the hammer down until a clicking sound is heard.

  3. cHsMXUUMLhQgwMVg
    • Don’t staple your hand, or anyone else for that matter.

    • Congratulations! You have successfully replaced staples in your stapler.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sequoia Equities

Member since: 22/01/15

225 Reputation

One comment

Wnen I tried to load the staples, the spring came loose. But I do not know where to reconnect it and have a loose short plastic rod!

Brian Gray -