Introduction
In this guide I will explain how to replace the micro USB port on a Steelseries headset with a USB C port.
-
-
After you've taken off the ear pad there should be 3 screws to unscrew. You need a TR6 screwdriver to unscrew them.
-
-
-
After the plastic cover has been taken off you should see the PCB. It has 3 screws that you need a PH000 screwdriver to unscrew.
-
To lift the PCB out I found it easiest to lift on the top (opposite side of usb port) and push lightly on the volume wheel. Just be carefull not to break anything while lifting. I broke the usb port off when doing this.
-
-
-
You need to make sure that you are attaching the port the right way or you could possibly destroy it when plugging it in to charge.
-
To reassemble your device, follow some these instructions in reverse order. Dont desolder your new USB port.
5 comments
DO NOT DO THAT LIKE THIS!!!
You destroyed PCB and broke layers.
You needed to use a small electronic part socket USB-type-c female instead USB-plate.
Well it may not be the best way to do it, but it works. The headset has worked flawlessly for months now. I am not particularly experienced in soldering, but I wanted to share how I did it.
Kireobat -
Even though it's not the perfect repair, it's good enough for me if it works. Looks easy enough to try and repair them myself. Thanks for sharing dude and I appreciate you giving them a longer life rather than throwing the whole headset into the trash.
My micro usb port came off and I'm planning to repair it. Stumbled upon this guide and wanna make sure if what you did here would also work for mine. Here's what it looks like imgur link. Also do you have any recommendations, tips, or something. Thank you!
I think it could work. It probably smart to have solder flux ( i didnt have it at the time ). FYI the headset is still working after all this time.
Kireobat -