Visual Land Prestige 7L Front Facing Camera Replacement

Written By: Greg Azzalina
  • Comments: 0
Visual Land Prestige 7L Front Facing Camera Replacement

Difficulty

Moderate

Steps

5

Time Required

30 minutes

Introduction

If your camera is not working, you may need to replace it completely. Following this guide will allow you to do so.

  1. FFjnmhnHcLiSBsyO
    FFjnmhnHcLiSBsyO
    4ThhLqK2W4u1NwWD

    • Remove the two 8mm Phillips Head screws located at the bottom of your device.

  2. JC6bFVXUpTD2FcyD
    JC6bFVXUpTD2FcyD
    KjQQMSpJdIfU6mXe
    JRFUHDMxvBAQcBLo

    • Insert the spudger between the two pieces of the case around the media ports and pry them apart.

    • We found the best way to get the spudger inside the case was to insert in into the SD card slot. Be sure to only insert the spudger a shallow amount and be careful not to damage any of the inside of the device.

    • Finish unsnapping each plastic piece holding the device together along the bottom.

  3. YBnRGCBLbarhLZV2
    YBnRGCBLbarhLZV2
    6yHCNlOZPDylbD6r
    nYCeIWPycRgT3MQH

    • Move the spudger down the rest of the case, separating each side, and finally the top.

    • Pull the back off and place it to the side.

    • Without a back panel for protection, be sure place your device on the table screen-side down to avoid damaging the internal circuitry.

  4. ALY4lnTLAEExG36h
    ALY4lnTLAEExG36h
    WtcuP2THOpIdDmvW

    • Remove the adhesive padding.

  5. JFhrpu2PBG36XjI1
    JFhrpu2PBG36XjI1
    Bdg3fHhKPNAFWSTR

    • Unclip the connector that attaches the camera to the motherboard.

    • For more information on unclipping connectors see this How To Guide

    • Do not pull on the camera until you're sure that it's unclipped, the gold connection will rip.

    • Gently pop the camera out of the connector and off the case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Greg Azzalina

Member since: 28/01/15

263 Reputation

0 comments