Introduction
As it controls the whole phone, knowing how to remove the motherboard of the ZTE Speed is important.
-
-
Remove the seven 3.175mm Phillips head screws from the inner back located at the top, upper-middle-right, middle-right, lower-right, and bottom.
-
-
-
With the plastic opening tool the spudger, gently pry off the inner back.
-
Be careful not to pry it off too hard, as it is just a plastic covering.
-
-
-
Remove the one 2.381mm Phillips head screw from the motherboard located in the upper-middle part of the phone next to the bottom left corner of the back camera.
-
-
-
Using the spudger, gently pry up all ZIF connectors
-
ZIF connectors have a tiny tab that needs to be flipped up in order to safely remove the cable
-
Using same spudger, gently pry up the orange flat top connector
-
To reassemble your device, follow these instructions in reverse order.
