Introduction
This guide will show you how to disassemble and remove the speakers in the iHome iAVS16, we hope you can use our guide to help you.
-
-
Remove the four 1.7 mm Phillips #0 screws located on the bottom of the device.
-
Lift up the bottom of the device.
-
-
-
Remove the two 1.7 mm Phillips #0 screws holding the white face place onto the inside of the device's bottom.
-
Using an iFixit opening tool on the side without the black adhesive, carefully lift up the white face plate.
-
-
-
Using the tweezers, lift up on the black tab holding the ribbon cable down.
-
Carefully pull the ribbon cable back and out of the slot.
-
-
-
Remove the two 1.7 mm Phillips #0 screws holding the power board in.
-
Carefully flip the board over.
-
Remove the red connector from its socket with a pair of tweezers.
-
-
-
Insert an iFixit opening tool into the lining on the front casing and pry it apart. Do this for both sides.
-
Further remove the front casing off from the device manually with your hands.
-
-
-
Carefully flip the LCD display over to expose the ribbon cable connecting it.
-
Lift the black tab holding the cable down, and carefully put it out of the socket.
-
-
-
Using tweezers, unplug the white, red, and blue connectors from the motherboard by pulling each out.
-
-
-
Using an iFixit opening tool, push the tab under the top of the device to create a gap.
-
Insert the iFixit opening tool in the gap, and slide it across to remove the top casing.
-
-
-
Remove the top cover of the device.
-
Remove the five 1.7 mm Phillips #0 screws on the top of the device.
-
-
-
Remove the four Phillips screws on the back of the front half of the device holding the speakers in.
-
Push the speakers out of the back of the device.
-
Thank you for using our guide, we hope that it helped you fix your project
