Nostalgia Electrics PCM805 Wiring Teardown

Written By: Joshua Harriger
  • Comments: 0
Nostalgia Electrics PCM805 Wiring Teardown

Difficulty

Moderate

Steps

4

Time Required

10 minutes

Introduction

  1. iiLSZ6eBRmIAZdKU
    iiLSZ6eBRmIAZdKU
    62gqUaTqraRukNwk

    • Unplug the device before following this guide.

    • First, place the device on its side, making sure the switch is not facing down.

    • Remove the eight 12mm Phillips #02 screws from the base.

  2. iDkKKOYTSlDkCh6w

    • Gently separate the panel from the device.

    • Be sure not to tug at the wires that are still connected.

  3. ImQ6xLsPOyhyLZtY
    ImQ6xLsPOyhyLZtY
    1VTlcYbRF2G2sEus

    • Locate the tie strap holding the wires and cut with a pair of scissors.

    • Use care not to snip the wires.

  4. L4McKDHk3WVFSRSi
    L4McKDHk3WVFSRSi
    jByfMorNCDmOrDrD
    D5rtlOQBNLZRwuVS

    • Make note of the wiring arrangement of each bundle before this step.

    • Using wire cutters, cut each wire as close to the wire connector as possible.

    • Cut the wires in both bundles.

    • To reassemble the cotton candy maker after cutting the wires, follow our rewiring guide.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Joshua Harriger

Member since: 13/01/15

309 Reputation

0 comments