2006 Dodge RAM Turn Signal Bulb Replacement

Scritto Da: Eddie Echegoyen
  • Commenti: 0
2006 Dodge RAM Turn Signal Bulb Replacement

Difficoltà

Moderate

Passi

6

Tempo Necessario

15 minuti

Introduzione

If the blinker bulb on your Dodge Ram 2006 is not flashing, it may be due to a burnt bulb. Use this guide to help replace a burnt bulb. In step two, when you pull the light casing out, wires will be attached to the case. Please do not touch the wires as they are exposed electrical wires and may cause harm to you or the cables themselves.

  1. 6Ky3O3okNHEj6AmN
    6Ky3O3okNHEj6AmN
    NkMhvgCLGMJvnEyA
    PFNeRnbGmYssTwUT

    • Remove the two screws securing the light to the truck using an Allen wrench.

  2. 16HmKfbRSwQKgOHA
    16HmKfbRSwQKgOHA
    CqpeH2KKeJFNhG1R
    LIvMQ3smv5wCBuMw

    • Pull the light casing out of the socket.

    • The wires exposed at the back of the light case are dangerous to touch as they are exposed electrical wires. Do not interact with them.

  3. cwkhpmSB2ZrjcI4l
    cwkhpmSB2ZrjcI4l
    q1jcLmVZDGGp3ODl
    jjZNSAXfnuiIRq4C

    • Remove the four screws from the light case.

  4. p56BFlT1jESpUO3n
    p56BFlT1jESpUO3n
    ixBhsGYEn1SAcAv2
    gqAcXpjLJCdPJIMb

    • Remove the light case from the light bulb holders.

  5. VPGVWmZFF4OIX5A4
    VPGVWmZFF4OIX5A4
    GgUYbDNqBqxTHD2K
    WTXxOwXSCjudTDg1

    • Replace the light bulb by gently pulling the original light bulb out.

    • Replace the lightbulb with a new one.

  6. 6Dl2Won12ueBJcDv
    6Dl2Won12ueBJcDv
    TCCHN6OXYr1UcWBo
    oZYIYtRBUaJfPhir

    • Reattach the lightbulbs to the light casing and put the 4 screws back in.

    • Pop the light casing back into place by making sure the two pointed ends go into the holes.

    • Replace the two screws that secure the light to the truck using an Allen wrench.

Autore

Eddie Echegoyen

Membro da: 18/10/23

133 Reputazione

0 commenti