Alienware X51 RAM Replacement

Scritto Da: Kathleen
  • Commenti: 0
Alienware X51 RAM Replacement

Difficoltà

Moderate

Passi

8

Tempo Necessario

15 minuti

Introduzione

This replacement can be applied to the Alienware X51 R1, as well as the future models: the R2, or R3. Replacing the Ram if your PC randomly shuts down. Refer back to our troubleshooting guide.

  1. lF6T2kEYRC5JRnMb

    • Place the PC so the name "Alienware" is on top and facing you.

    • Slide the front panel towards you and lift up.

  2. peIl5XWGAFTHafil

    • Fully disconnect the panel by unplugging the lighting cord going into the PC's internal system.

    • Remove the front panel from the rest of the device.

  3. Ng6PMV6faCcjbYNp
    Ng6PMV6faCcjbYNp
    ClhXLqYD3tccv322

    • Remove the two 2.0 mm screws holding the fan protector in place using a Phillips #1 screwdriver.

    • Remove the protector holding the fan in.

  4. QS6PWnGMVAPRvmeW

    • Disconnect the Molex KK connector from the fan.

  5. BTYFYdeDvxiSHSei
    BTYFYdeDvxiSHSei
    JiUPGSDOxqDCbG3O
    bWkrsPC1MfRqyfMe

    • Use a Phillips #1 screwdriver to loosen the four spring screws around the fan until you hear a click.

    • Gently pull back the clips and remove the fan by pulling it out.

  6. hYcVgThEbPR5ILW1
    hYcVgThEbPR5ILW1
    Lo6TBxyMQOoNjoul

    • Disconnect the optical-drive data and power cable.

  7. OY5oKB2mLH2xMAhr

    • Remove the one 1.0 mm screw using a Phillips #1 screwdriver.

    • Remove the disc drive from the PC.

  8. dKfNqBYCFtpT1hgF
    dKfNqBYCFtpT1hgF
    QUWBQSlceKAHlRHi
    UO6BjophUbLkpwfm

    • Pull apart the clips that hold the RAM sticks in place.

    • Remove the RAM sticks.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Kathleen

Membro da: 02/10/23

79 Reputazione

0 commenti