Apple PowerBook G3 400 RAM Replacement

Scritto Da: Ian
  • Commenti: 2
Apple PowerBook G3 400 RAM Replacement

Difficoltà

Easy

Passi

9

Tempo Necessario

10 - 15 minuti

Introduzione

  1. dnVdtC12Z4SymOnd

    • Pull the keyboard tabs toward you while lifting up on the keyboard until it releases from it's hold.

    • To lift the keyboard out pull it up and away from you. Then place the keyboard on the track pad.

  2. QkhelGLLbaJlyGSh

    • Pull the keyboard ribbon vertically from the logic board to release connection.

    • The connector may be tight and difficult to remove. If stuck try rocking the connector back and forth while pulling up until it releases. This same process can be used for many of the connectors on this device.

    • Remove battery and CD/DVD drives before proceeding any further.

    Don't remove the connector. Just flip the keyboard over and lay it on the hand rest.

    Tobias Welti -

  3. WUSFYkf3PLxY2jTc

    • Your computer should look approximately like this.

  4. NaaZrQWSWvTXFDa1

    • Remove the two silver Phillips #1 screws that attach the heat shield to the metal framework.

    • Lift the heat shield up and toward you.

  5. HqxqujRZwT21wEYZ

    • Pull the PRAM battery cable vertically upward to disconnect it.

    • Remove the battery by pulling up and to the left.

    Unnecessary to remove the PRAM battery, nor anything else. Instead of step 5, you can directly proceed to step 11, just be careful when removing the bracket.

    Tobias Welti -

  6. S1ZQeOBsnG5HvRIN

    • Remove the two T8 Torx screws that attach the heat sink to the processor.

    • Remove the long silver Phillips #1 screw from the heat sink.

  7. kgWJQBHDxWkpi3nK

    • Lift up the heat sink unit from the left side and remove.

  8. Op21L1GsVgJXSQok

    • Lift the processor on the right side and pull directly up.

    • The RAM chips should be in the slots on the processor.

  9. DMvo4EXuE1wgOS5R

    • After removing the RAM, your laptop should now look like this.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Ian

Membro da: 18/04/11

57 Reputazione

0 commenti