Atari 5200 Joystick Repair

Scritto Da: Alan Abelson
  • Commenti: 0
Atari 5200 Joystick Repair

Difficoltà

Moderate

Passi

5

Tempo Necessario

15 - 45 minuti

Introduzione

The controller's joystick is connected to a sensor via sliding plates, which then move two knobs(one per axis), which are placed inside two pots whose movement the sensors detects. The knobs can occasionally get dislodged out of the pots, causing a "stuck" and undetected joystick.

  1. bpOJmLI6VaMGKSTO
    bpOJmLI6VaMGKSTO
    fECiUYODcgDEhmfK
    u5q1UqMZ2BrNYXrO

    • Turn the controller over, exposing the three screws on the back. Use a 6mm screwdriver to remove these screws.

    • Carefully slide and pull the two parts of the controller shell apart, exposing the innards.

  2. KPwWnP4ndlJRJDWS

    • Find the knobs (closest to the joystick and circled in red).

    • Locate the pots (closest to the circuitry and circled in orange). Keep track of these.

    • Align the joystick's metal bar into its cup.

    • Don't move any of the button circuitry, especially those of the START/PAUSE/RESET buttons.

  3. PcgtilKuNX6IKJ6E

    • Use a spudger to remove the top frame.

    • Take off the plate.

    • Remove the rubber buttons.

  4. XscQFcgKdkuiOgHW
    XscQFcgKdkuiOgHW
    v1MFIPndN3UiDfBa

    • Realign the top and bottom of the controller.

    • Pull the circuit strip through the new space.

  5. gKeVnkhvXfblVlt1
    gKeVnkhvXfblVlt1
    VgiXftEwnQWj5sXj
    NBfvMItbDZlFaogW

    • Return the start buttons to the top of the controller

    • Snap the frame back into place

    • Screw in the three screws on the back.

Autore

Alan Abelson

Membro da: 26/09/14

233 Reputazione

0 commenti