Beats Studio 2 Wireless Speaker Replacement

Scritto Da: Mike Rosiello
  • Commenti: 1
Beats Studio 2 Wireless Speaker Replacement

Difficoltà

Difficult

Passi

6

Tempo Necessario

45 minuti - 1 ora

Introduzione

If the sound of one of the earphones from your Beats Studio 2 Wireless headphones is distorted, muffled, or completely silent, the speaker may need replacement.

Before performing this repair, look at the troubleshooting page for other possible fixes.

This guide requires desoldering and soldering. If you don't have this skill or need a review, take a look at the How to Solder and Desolder Connections guide.

  1. PBv6pOLJQGYcw1kA
    PBv6pOLJQGYcw1kA
    YQX2tKcyjALbnBBv

    • Insert a spudger between the plastic part of the left headphone and the ear cushion.

    • Work the spudger around the periphery of the base of the cushion and gently pry it off the head phone.

  2. wBmpWXgCnMXrHooL
    wBmpWXgCnMXrHooL
    2ZxE2BQpkS2kDIJA
    fWrGSKPFOBgxBIQd

    • Pull the rest of the cushion away from the adhesive with your hands.

  3. OG2NvIyU52FxXJXE
    OG2NvIyU52FxXJXE
    5KwHhN3sS4aDUYvG

    • Using the Phillips #00 screwdriver, remove the screws holding the speaker in place.

    • If the speaker is on the side with the charging port be sure to keep the two screws holding the charging port separate.

  4. GREDq5QraBIkFK5i

    • Gently separate the speaker from the headphones.

    • Don't pull or yank the speaker from the headphones. They are connected together by wires that might be damaged.

  5. LYtvr6E5fDe1PNA1
    LYtvr6E5fDe1PNA1
    SgmMIShcvtFsHSae

    • Gently pull the wire with rubber connectors off of the speaker.

  6. 5Q1xDERjqDY2gYNd

    • Use a soldering iron to desolder the two connections.

    • For details on how to solder and desolder, refer to the How to Solder and Desolder Connections guide.

    • A soldering iron can produce very high temperatures, and can burn skin. Use with caution.

    • Note the position of the speaker in its housing, then carefully remove the faulty speaker.

Conclusione

After soldering the new speaker, reassemble your device by following the steps in reverse order.

Autore

Mike Rosiello

Membro da: 20/03/23

313 Reputazione

Un commento

I didn't need to replace a speaker but just touch up the solder joints, this was a great guide! Thank you!

William Pryor -