Beats Studio3 Wireless Battery Replacement

Scritto Da: Lourdes Dejesus
  • Commenti: 3
Beats Studio3 Wireless Battery Replacement

Difficoltà

Moderate

Passi

5

Tempo Necessario

10 minuti

Introduzione

Use this guide to replace the battery in your Beats Studio3 Wireless headphones (model number: A1914).

The battery helps the Beats Studio3 Wireless headphones to power on. It's designed for long battery life of up to 22 hours for all-day. A failed battery will cause your Beats Studio3 Wireless to not turn on. You can take a look at the bottom right ear pad to check if the five lights are on. In some cases, your Beats Studio3 Wireless will have faulty charging due to a deteriorated battery.

  1. xQuL4GnFlfwVQEJE
    xQuL4GnFlfwVQEJE
    Z5Gdcc1QreOLcNYn

    • Use a pointed nylon spudger to remove the center circular panel on the right side of your device.

    • Be gentle while removing this piece as it is glued on with adhesive.

  2. QJVoHlutgLysPvJU
    QJVoHlutgLysPvJU
    xXNhSVYXBdRd6MJF

    • Remove the four 3.5 mm screws using a Phillips #0 screwdriver.

  3. DRWPLegCbR2AJLJH
    DRWPLegCbR2AJLJH
    3gAEffT6YaPwFKVL
    fGuVNBWBfOSup5ru

    • Using a pointed nylon spudger, remove the tab located on the inner part of the headband labeled "R."

    • Place the nylon spudger in between the side panels and push inward going from bottom to top to separate both sides of the panel.

    • The panel will pop open after separating.

  4. tZm2ihIBBtVradBk

    • Place the nylon spudger underneath the battery, push inward and separate the battery from the inside.

    • Never use sharp tools to pry batteries. Metal spudgers can puncture an unprotected battery, potentially causing a fire.

  5. mBRmcTeXbJbGTAsA
    mBRmcTeXbJbGTAsA
    PBWsKtETCVSCJG4g

    • Use a nylon spudger to lift up the glue sticking the wires down.

    • Use a nylon spudger to lift the connector to disconnect the battery.

    the glue on the connector was a nightmare in my headset. Used a soldering iron to weaken the glue as described in a youtube video i found, but it worked out in the end :)

    seb -

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Lourdes Dejesus

Membro da: 16/03/23

204 Reputazione

2 commenti

Should the glue be reapplied or is it okay to simply place back on?

Jake Allen -

the replacement batteries usually come with a gluepad on the back.
The connector its up to you - you risk the chance of the connector coming lose and u have to reopen the headset. But ill take the chance for now, lets see how it holds up without new glue.

seb -