Bendix Magneto Gear Replacement

Scritto Da: Kelsi English
  • Commenti: 0
Bendix Magneto Gear Replacement

Difficoltà

Easy

Passi

3

Tempo Necessario

5 - 15 minuti

Introduzione

This guide provides instructions for removing and replacing the gear in the Bendix Magneto: S6RN-23. The Magneto is an elecrical generator that uses magnets to create electrical current pulses. It is often used in ignition systems. A broken gear can stop the Bendix Magneto from rotating, causing incorrect timing of the system. This would cause an engine to either run erraticly or stop altogether.

  1. iqYTVUxuGZyGeb6q

    • Use a #2 flat head screwdriver to remove the five screws from the body of the Magneto.

  2. UxeSdPaxBbm6fnH2

    • Locate the spark plug lead.

    • Use Milbar snap ring pliers to remove the snap ring.

    • The snap ring can be difficult to remove. Make sure the pliers go into the holes of the snap ring.

    • Wear safety goggles when removing the snap ring. The snap ring can shoot out on accident.

  3. N22IHC5TFlHAKwtD

    • Remove the gear to replace it.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Kelsi English

Membro da: 26/09/12

501 Reputazione

0 commenti