Canon PowerShot SD700 LCD screen Replacement

Scritto Da: Emilio Rossi
  • Commenti: 1
Canon PowerShot SD700 LCD screen Replacement

Difficoltà

Moderate

Passi

9

Tempo Necessario

10 - 15 minuti

Introduzione

Follow these steps to remove and install a new LCD screen.

  1. qYKF5GXMXCgO5D5O

    • Turn off the camera by pressing the power button above the LCD screen.

  2. tuRtbvBEwOERpACe

    • Remove the two, small screws on the bottom of the camera using a Phillip's #00 screwdriver.

  3. UJyBXyDKiI5Jqh3J

    • Use a Phillips #00 screwdriver to remove the two, small screws on the right side of the camera.

  4. Qs2evXXk4gNhZM5q

    • Use a Phillips #00 screwdriver to remove the screw on the left of the camera under the A/V out Digital label.

  5. YBbt6BODIFR5p5dM

    • Use a Phillips #00 screwdriver, remove the screw on the bottom of the camera near the battery and memory card slots.

    • This screw will be longer than the rest of the screws.

  6. Nk1plWGxIQHAJwE4

    • Remove the front, back, and side casings from the camera and set to the side.

  7. n1WYQbeYHPrgrM2y

    • Remove the two screws that connect the LCD and backlight to the main body of the camera.

  8. LBETDPbrXRCCmXus
    LBETDPbrXRCCmXus
    tryMFr3WXKt1DAxI
    SjmlgCxLFm3cbwcj

    • Gently pry the LCD and the backlight from the main body of the camera.

    • Gently pry the LCD from the backlight.

    • The thin ribbon cable is for the backlight.

    • The thick ribbon cable is for the LCD screen.

  9. AeDWrIcOHPDFl5er

    • Carefully lift the ZIF connector that covers the thick ribbon cable.

    • This ZIF connector is fragile. Use caution when lifting it from its down position.

    • Insert the new LCD and reassemble the camera.

    Where I can buy the Canon PowerShot SD700 LCD screen Replacement

    Fnu Sumaryanto -

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Emilio Rossi

Membro da: 07/04/11

113 Reputazione

0 commenti