Chocomaker Apple Dipper 9820 Disassembly

Scritto Da: Sophie
  • Commenti: 0
Chocomaker Apple Dipper 9820 Disassembly

Difficoltà

Moderate

Passi

8

Tempo Necessario

25 - 40 minuti

Introduzione

The Apple Dipper Model 9820 is a kitchen appliance used to make dips and is produced by the brand ChocoMaker. This guide will walk you through how to take apart the Apple Dipper. There are no additional special skills needed to follow this disassembly guide.

  1. pQYFPXUxjP1o3aVN
    pQYFPXUxjP1o3aVN
    urFaxEenIvVw5IZv

    • Remove the Apple lid.

  2. ecsPXJrxAGBqtZhQ
    ecsPXJrxAGBqtZhQ
    ybtF1q3KsRJmtEKK

    • Remove the red rim by twisting it counterclockwise.

  3. akbKIiWhGXG5py1q
    akbKIiWhGXG5py1q
    4IPSISk3OilwiHYM
    nG5hhFNNlkFGCgFI

    • Unscrew the 4 screws around the exposed orange rim with a Phillips #1 screwdriver.

  4. BC1NP2QZsonYaqGy
    BC1NP2QZsonYaqGy
    W4sJcgsjxAmblJro

    • Lift the white bowl and metal bowl (with orange rim) as far as they go, in order to access and unscrew two screws from the metal part.

    • Unscrew using the Phillips #1 screwdriver.

    • These screws have a white circumference and are attached to the metal.

  5. bE3kDVdDWC2K3M54
    bE3kDVdDWC2K3M54
    yJbGU1olRyHVmPtw

    • Remove the heat plates from under the metal plate holding them down.

    • This will allow you to completely remove the white bowl and metal bowl with the orange rim, leaving you with the red outer bowl and partially exposed circuit.

  6. SNWfoGlGWn1TswOD
    SNWfoGlGWn1TswOD
    FOUymOWqNxLuMKw1
    SU4bZLU5a1uJbQRL

    • Flip the apple.

    • Remove the bottom lid by using the Phillips #1 screwdriver to remove the four screws.

  7. K6B4UtipSHaJRsqZ
    K6B4UtipSHaJRsqZ
    OuLjVTHTUSJFhN23
    uY3ROVPK2WvUbWpt

    • Remove the 2 mm screws from the wire holder with a P106A screwdriver.

    • These screws are only holding the wire for it to come out of the apple in the right way. (They are two screws attached to a small orange thing)

  8. cbls2t25DnLJMPUn
    cbls2t25DnLJMPUn
    V1FXCgHhqIHiCc3D

    • Circuitry is exposed.

    • This device is controlled by a switch which influences where voltage and current occurs within the circuit.

    • There is one are two loops: one accounts for the "warm" setting and the other accounts for the "melt" setting.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Sophie

Membro da: 13/09/23

207 Reputazione

0 commenti