Crain Jamb Saw 775 2014 Power Cord Replacement

Scritto Da: Tarun Thiruma
  • Commenti: 0
Crain Jamb Saw 775 2014 Power Cord Replacement

Difficoltà

Moderate

Passi

8

Tempo Necessario

5 - 15 minuti

Introduzione

This guide demonstrates how to replace the power cord on your Crain 775 Jamb Saw.

  1. 13ZUVmCYv5prVSED

    • Unplug the power cord before you begin.

    • Use a Phillips #2 screwdriver to remove the eight screws securing the saw housing:

    • Four 20 mm screws

    • Two 50 mm screws

    • Two 55 mm screws

  2. fJj5wAKg1eoBGBkR

    • Remove the metal housing bracket.

  3. sqXt4WFXXFYrGrdK
    sqXt4WFXXFYrGrdK
    i4Gnh5x54mfivoMX

    • Remove the saw housing.

  4. Y2rSgU3R1EySG14T

    • Use a Phillips #2 screwdriver to remove the two screws securing the power cord grommet retention bracket.

  5. HDQDAvNYbCU15W4e

    • Remove the power cord grommet retention bracket.

  6. QVdDKGe2FBdSemYf
    QVdDKGe2FBdSemYf
    WCOIMPYtiTqlIFlj
    LWGKyTsPDocOLJeK

    • Use a Phillips #2 screwdriver to loosen the two screw terminals securing the power cord wires to the main switch.

    • Remove the power cord wires from the main switch.

    • Take note of which lead connects to which terminal for reassembly purposes.

    • During reassembly, if the replacement power cord is not pre-fitted with crimped wire ends, ensure about a 1/2" of insulation is stripped from the end of the wires. Twist the wire strands before inserting them into the terminals.

  7. NqXpmvjcQVqAWDwe

    • Remove the power cord and power cord grommet from the rest of the saw body.

  8. YIintCgsPhAJoZnl
    YIintCgsPhAJoZnl
    hvLAwhoemslcxfhx
    2DiuXcFHkA4QnCcD

    • Slide the power cord out of the power cord grommet.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Tarun Thiruma

Membro da: 20/11/19

35174 Reputazione

0 commenti