Crain Jamb Saw 775 2014 Switch Replacement

Scritto Da: Tarun Thiruma
  • Commenti: 0
Crain Jamb Saw 775 2014 Switch Replacement

Difficoltà

Moderate

Passi

7

Tempo Necessario

5 - 15 minuti

Introduzione

This guide demonstrates how to replace the trigger/switch on the Crain 775 Jamb Saw.

  1. 13ZUVmCYv5prVSED

    • Unplug the power cord before you begin.

    • Use a Phillips #2 screwdriver to remove the eight screws securing the saw housing:

    • Four 20 mm screws

    • Two 50 mm screws

    • Two 55 mm screws

  2. fJj5wAKg1eoBGBkR

    • Remove the metal housing bracket.

  3. sqXt4WFXXFYrGrdK
    sqXt4WFXXFYrGrdK
    i4Gnh5x54mfivoMX

    • Remove the saw housing.

  4. YJAfxG1bEW4wIYGU

    • Use a Phillips #2 screwdriver to loosen the four screw terminals securing the power cord and motor wires.

    • Take note of which wire connects to which terminal for reassembly purposes.

    • The switch is not secured to the housing; be sure to hold it in place when removing the motor and power cord wires.

  5. bXrHwJRuTcKWoagh
    bXrHwJRuTcKWoagh
    YmVhQkUxfNIKc4BS

    • Remove the power cord wires from the main switch.

  6. 5KYIsBsXUmcsHYsN
    5KYIsBsXUmcsHYsN
    IClrUnWRJYGQWidE

    • Remove the motor wires from the switch.

  7. TGYpHbU6JsQXbcB2

    • Remove the switch.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Tarun Thiruma

Membro da: 20/11/19

35174 Reputazione

0 commenti