Creality CR 10s Pro V2 Nozzle Replacement

Scritto Da: Angelina Jimenez
  • Commenti: 0
Creality CR 10s Pro V2 Nozzle Replacement

Difficoltà

Moderate

Passi

5

Tempo Necessario

15 - 30 minuti

Introduzione

Nozzles on a 3D printer are considered consumable items, meaning they are commonly replaced during a 3D printer's lifespan. The more you print the quicker the nozzle will wear out.

Reasons to replace a nozzle include:

  • Desired nozzle diameter
  • Clogged nozzle
  • Nozzle deterioration
  • First layer failure
  • Print speed

This guide will demonstrate how to replace a 3D printer nozzle for the Creality CR 10s Pro V2.

  1. BUHUPmWcD1o23XBE
    BUHUPmWcD1o23XBE
    VHnOm2DJXb6DYxRJ
    gF1LwuSVGIGyay4A

    • Using a 2 mm hex key, remove the two screws that secure the fan cover.

    • While removing the screws, hold the fan cover with one hand to prevent it from falling once it's detached.

    • Position the fan cover in a way that doesn't damage the external wires.

    • Remove the silicone sock from the extruder nozzle.

  2. JwrFXATyUurWeYHI
    JwrFXATyUurWeYHI
    TE3lNHGkxdhrPXLb
    FbnCvwiSQ6rNebvU

    • Go to your LCD Screen >Temp > Manual >Nozzle Pre-Heat.

    • Pre-heat the nozzle to 230C.

    • The heat will loosen the nozzle so it can be unscrewed.

  3. A2xgZaEHcGAuZKHK
    A2xgZaEHcGAuZKHK
    rZWM22x1EmUOMJOL

    • The equipment is hot! Be careful when working with the metals parts so you don't burn yourself.

    • Once the nozzle is sufficiently heated, use an adjustable crescent wrench to firmly hold the heater block.

    • With the other hand, use the tappit wrench to unscrew the nozzle.

    • Allow the printer to cool down.

  4. tM3Ii3MvrDIQ1auC
    tM3Ii3MvrDIQ1auC
    hyX3VYCZtdo3DAIs

    • Hot Equipment!

    • Once the heater block is cooled down, slightly thread the new nozzle onto the heater block.

    • Manually set the nozzle pre-heat to 230C and finish threading the new nozzle.

    • Be careful to not over-tighten the nozzle. Overtightening can also damage the heater block or the nozzle.

  5. sYcOAGKQsda1LI2b

    • Using the 2 mm hex key, replace the fan cover to the extruder.

    • It is important to relevel the print bed after changing the nozzle. Such change can affect the distance between the nozzle and the print bed.

Conclusione

To ensure the nozzle replacement has been followed correctly, calibrate your 3D printer.

Autore

Angelina Jimenez

Membro da: 25/05/23

121 Reputazione

0 commenti