DeWalt DC970 Battery Cells Replacement

Scritto Da: Jonathan Hamel
  • Commenti: 2
DeWalt DC970 Battery Cells Replacement

Difficoltà

Easy

Passi

5

Tempo Necessario

5 minuti

Introduzione

If the battery of your drill is not giving the drill power, a problem you could have is deteriorated battery cells. This guide will show you how to replace the battery cells.

  1. iFAWbJDnhLhVdAlL

    • Compress the buttons on either side of the battery and lift the drill away from battery.

  2. rtlRZBdsGVSNifqH

    • Remove battery from drill.

  3. 1yFQgoCLklVkMLMq
    1yFQgoCLklVkMLMq
    j2SwsRxOadaHVxHK

    • Remove the six 19 mm, Torx Security 15 screws from the top of the battery.

  4. wtqJee2kT5pJAiHn

    • Pull off the battery cover, exposing the battery cells.

    • Be careful to not damage the batteries, if damaged they may explode.

  5. RxVhEiSRuEfcRFkv
    RxVhEiSRuEfcRFkv
    nO6LZafmSXHQJNPw
    SYVnevrSfNwR6JC2

    • Remove the old battery cells by slowly pulling them out of the top piece of the battery.

    • The best is to recycle the old battery cells.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Jonathan Hamel

Membro da: 10/03/16

612 Reputazione

2 commenti

It is not clear from the guide if it is all cells that are replaced or single cells.

If single cells, it would be very nice if instructions were shown how to test each cell, and replace single cells.

/Søren

Andersen -

Where can one get the replacement cells?

Samuel Harley -