Disassembling Western Digital Essentials HD Anti-vibration rubber pieces

Scritto Da: Gaetan
  • Commenti: 0
Disassembling Western Digital Essentials HD Anti-vibration rubber pieces

Difficoltà

Very easy

Passi

7

Tempo Necessario

1 minuto

Introduzione

  1. uvxWBTDKIPttXHgw
    uvxWBTDKIPttXHgw
    rh6K4MjfFumsOhsy
    PwvIVAUIetotCJPC

    • Use a large plastic opening tool along the rear panel:

    • There are 4 clips to release.

  2. JmJWWKccxHH3J1AB
    JmJWWKccxHH3J1AB
    eqWpvy16PmHaWYUr

    • Slide the cover along the plastic frame.

  3. UpVl6EVaUMH2tTH2

    • Slide off the largest plastic pieces.

  4. PLRIJKVMRC2nURIW
    PLRIJKVMRC2nURIW
    HTR4KdVhPGxtkgGr
    2W1qqGFmXYcYjRSD

    • Bend the second small plastic piece to release it from the rubber piece.

    • Now you can slide it out.

  5. OXvsTZRfqsxToJpi
    OXvsTZRfqsxToJpi
    3qPBFUFpiqLV3yCa

    • Slide out the hard drive as shown in the picture

    • Make sure to slide as shown or you may damage the USB bridge logic board.

  6. HYDcVseasGkYWJnO
    HYDcVseasGkYWJnO
    NPrZjPEEIAIFrMPi

    • Remove the 4 rubber piece from the plastic frame at each corner.

  7. 1H5bskkoQnJDakTZ

    • Remove the rubber piece from the SATA/USB bridge logic board.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Gaetan

Membro da: 26/12/12

9574 Reputazione

0 commenti