Drift HD 720 LCD Screen Replacement

Scritto Da: Hector Rodriquez
  • Commenti: 4
Drift HD 720 LCD Screen Replacement

Difficoltà

Moderate

Passi

11

Tempo Necessario

Nessuna stima

Introduzione

If your device seems to be turning on but the screen isn't displaying anything, you may be able to fix the issue by replacing the screen.

  1. CQSsS3PpV4C45aBW
    CQSsS3PpV4C45aBW
    mwTp6DuBthJWIDnr

    • Unscrew the back plate counterclockwise until it comes off.

  2. IaGYOOVGZMGHkRbW

    • Push the black battery tab next to the battery to get the battery out.

    • Remove the battery.

  3. MI1npv2WxgvClrmj

    • Remove six 8mm long Philips head screws with the J0 Philips head from the outer case.

  4. TxTqpqLDdvcnurvt

    • Remove the back case from camera body.

  5. Fh5EoeUUFTueEQBy

    • Carefully remove the battery housing from the camera body.

  6. uHyi4Pkb1O2pCJOY

    • Use J0 Phillips head to remove two 6mm long Phillips head screws from the motherboard.

  7. HHWKC2EvwHjbTHtC

    • Remove the motherboard (green) from the front case housing.

  8. mc3VPSiI6s3cnEfA

    • Use the J0 Phillips head screws to remove two 5mm long Phillips head screws from the plastic bracket holding LCD in place.

  9. krQxdTYZgGMQQsGc

    • Remove the LCD screen from the front cover.

  10. 4uxGVaQTgBgcwCkT

    • Slide the black bar toward the LCD screen in order to remove the screen from slot.

  11. UV1FrTg1hFvcT5MY

    • Remove the LCD from motherboard.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Hector Rodriquez

Membro da: 23/09/15

422 Reputazione

4 commenti

Did you now where to find the replacement LCD screen? Thanks.

Rodrigo Forrequi -

I believe eBay should work.

Ruru Idahosa -

need a ribbon for stealth 2 any ideas?

dennis -

Good job! That guide indeed helped me a lot to give my Drift HD a good cleaning. Was a bit tough to remove the PCB, but after some fiddling it worked. Should be mentioned that you can remove the microphone from the surrounding rubber gasket so you can wash the gasket with ordinary soap. You can also separate the two PCBs (they are just stacked ontop of earch other using press-fit connectors)for easier access, e. g. if you want to clean and re-grease the collar of the lens unit. Also keep an eye on the aluminum cooler star. It has some heat conduction compond on it that you want to spread evenly. Don't wash it off entirely!

Volker Bartheld -