Epson Powerlite S4 Motherboard Replacement

Scritto Da: Claire Garland
  • Commenti: 0
Epson Powerlite S4 Motherboard Replacement

Difficoltà

Moderate

Passi

8

Tempo Necessario

20 - 25 minuti

Introduzione

The motherboard is a large component within the Epson Powerlite S4. This unit is located in the lower corner, and helps communicate with other technical components. Before starting this guide, ensure that the projector is off to prevent any hazard. If the motherboard is malfunctioning, chances are the device will not work.

  1. qGV5PbIltJvmBK1j

    • Press the power button located on top of the projector.

    • Remember to let the projector cool off completely after turning off the power before beginning the repair.

  2. bSTHg4nD4qZVfhX5
    bSTHg4nD4qZVfhX5
    EE25hj4yNbkPaZ2f

    • Using the Phillips #1 screwdriver, loosen the single captive screw on the right side of the projector.

    • The captive screw will loosen, but it cannot be fully removed.

    • Slide the panel off and remove it from the device.

  3. uuCHC4Ki4TKolGhW
    uuCHC4Ki4TKolGhW
    LFggSAuttjAvLfO3

    • Remove seven black 10 mm screws from the bottom of the device using a Phillips #1 screwdriver.

    • You may need to use a screwdriver extender to reach the seven screws.

    • Remove three smaller silver screws using a Phillips #1 screwdriver.

  4. hbkkaxFOUjZtIgYs
    hbkkaxFOUjZtIgYs
    BnqAQm3gQFPnsVXR
    NZJLdVdDLDhQprBq

    • Turn the projector so the power button is on top.

    • Gently pull up the cover until it pops off.

    • Do not pull too far; a ribbon cable still connects the top cover to the motherboard.

    • Disconnect the ribbon cable that attaches the cover to the motherboard.

    • Remove the cover and place to the side.

  5. rXqdAAGDW6BGWMPN

    • Remove the three screws holding down the motherboard using a Phillips #1 screwdriver.

  6. xwdViH4GXwUbP42X

    • Ensure that the two large cable cords located in the center are disconnected.

  7. gZwTTmSUjVMet6LV

    • Remove the nine cables that are running to the motherboard by pulling them up out of their sockets.

    • You may need a spudger or a plastic opening tool to disconnect all of the wires connected to the motherboard.

  8. ne4uGIB6SuKdEDSp

    • Carefully lift the motherboard from the edges.

    • Remove from base and set aside.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Claire Garland

Membro da: 21/02/23

229 Reputazione

0 commenti