Fit Lerdge V2 filament Sensor to Creality Ender 3 S1

Scritto Da: Tiny Machines 3D
  • Commenti: 0
Fit Lerdge V2 filament Sensor to Creality Ender 3 S1

Difficoltà

Moderate

Passi

3

Tempo Necessario

Nessuna stima

Introduzione

  1. NZu5YarEn3WVKxjy
    NZu5YarEn3WVKxjy
    W1snuAGJfDPM65mN
    eNVb1fQ4uWZKKlMv

    • Depin outside pins on the original sensor. Use the sharp point of an exacto tool or similar.

    • Be careful and only push the detent down enough to release the wire from the connector

    • In this case, only 2 wires are swapping, so marking the wires is not needed.

    • Gently, bend the detent back out at a slight angle so it catches when re-inserted.

  2. DIScJnFyACTIHMaQ
    DIScJnFyACTIHMaQ
    SRcAiUDnPCGZCTpl
    fhrZj6R3UpU6GFSh

    • Detent shown at a slight angle so it catches when re-inserted.

    • Wires should be twisted with outer 2 wires swapped.

    • Use included m3x16 SHCS to attach new sensor.

  3. hwHBwffN6EhAOWge
    hwHBwffN6EhAOWge
    xfLBNt22NjdLQOWG
    KCpBT2sqUCjLRU3T

    • This process only works with TM3D/ Insanity Automation firmware!

    • Navigate from the display to Configuration>Advanced>Filament>Runout Mode

    • While hovering over Sensor Low, press the knob.

    • Navigate to Configuration>Store Settings and press the knob. You'll hear a confirmation beep.

    • Alternatively, you can send M591 P1 S1

Autore

Tiny Machines 3D

Membro da: 16/11/19

2970 Reputazione

0 commenti